Sony XR-CA800 Getting Started, Resetting the unit, Detaching the front panel

Getting Started

Resetting the unit

Before operating the unit for the first time or after replacing the car battery, you must reset the unit.

Remove the front panel and press the RESET button with a pointed object, such as a ballpoint pen.

RESET button

Note

Pressing the RESET button will erase the clock setting and some stored contents.

Detaching the front panel

You can detach the front panel of this unit to protect the unit from being stolen.

Caution alarm

If you turn the ignition switch to the OFF position without removing the front panel, the caution alarm will beep for a few seconds.

If you connect an optional amplifier and do not use the built-in amplifier, the beep sound will be deactivated.

1 Press the power on/off button on the unit (or (OFF) on the card remote commander or the rotary commander).*

Tape playback or radio reception stops (the display remains on).

*If your car has no ACC position on the ignition switch, be sure to turn the unit off by pressing the power on/off button on the unit (or (OFF) on the card remote commander or the rotary commander) for 2 seconds to avoid car battery drain.

2 Press (OPEN), then slide the front panel to the right, and gently pull out the left end of the front panel.

1

2

Notes

•If you detach the panel while the unit is still turned on, the power will turn off automatically to prevent the speakers from being damaged.

•Do not drop or put excessive pressure on the front panel and its display window.

•Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in parked cars or on dashboards/rear trays.

Tip

When carrying the front panel with you, use the supplied front panel case.

continue to next page t

7