Troubleshooting

The following checklist will help you solve problems you may encounter with your unit.

Before going through the checklist below, check the connection and operating procedures.

GeneralNo picture

•The power cord has been disconnected. •The signal is weak.

tCheck all antenna connections and make sure they are all firmly pushed into sockets.

tMove the car to the good position for receiving.

•The fuse has blown.

•Data broadcasting is received. This unit does not support data broadcasting. (Displays “No Video !”.)

•Wrong “TV Type” is selected.

tPress 9, 5, 1, 4, 7 and (EPG) to change the mode to “NTSC” or “PAL”.

Good picture, but no sound

•Press (VOL)(+) or (ATT) on the card remote commander.

•Dolby AC3 signal is received. This unit does not support the Dolby AC3 signal. (Displays “AC3”.)

Sometimes see a squared pattern on the screen, your picture is “freezing” or a picture showing a TV with a noisy pattern.

•The antenna connection has become loose or disconnected.

tCheck all antenna connections and make sure they are all firmly pushed into sockets.

•There could be a transmission problem.

tThis normally is only a temporary situation and should correct itself.

Cannot access a particular channel, even using the number buttons.

•The parental lock has been activated.

tEnter your password to access the channel (page 13) or unlock the channel (page 20).

No response when pressing the buttons on the card remote commander.

•The battery may be exhausted.

Time or EPG is not displayed correctly.

•The programme of which time is not rectified, such as repeat programme, is received.

tAfter receiving another programme, turn off the unit once and turn it on again.

Messages

The following indications appear when a problem occurs in the unit.

ANT-1 Antenna feed overloadedAutomatically switched offANT-2 Antenna feed overloaded

Automatically switched off

The device will automatically switch off 5V output.

Antenna feed overloaded

Automatically switched off

The ANT-1 and ANT-2 are overloaded.

Program overflow

More than 2,000 channels were about to be stored. You cannot memorize any more channels.

HDTV Signal is not Supported

The unit received HDTV signal. This unit does not support the HDTV signals.

No Video Signal !No Signal !

No mpeg video data is input to the unit.

Bad Signal !

Mpeg data error occured in the unit.

No Video !

No Video PID is input to the unit.

Scrambled !

The unit received a scrambled programme.

Please wait for saving data.

The unit is saving the data.

25