Installation
Parts list
The numbers in the list are keyed to those in the instructions.
1 | 2 | 3 | 4 |
ø4 ⋅ 14 mm | 5.5m | 5.5m | 5.5m |
⋅ 4 |
|
|
|
Precautions
•Choose the mounting location carefully, observing the following:
—The unit is not subject to temperatures exceeding 55°C (131°F) (such as in a car parked in direct sunlight).
—The unit is not subject to direct sunlight.
—The unit is not near heat sources (such as heaters).
—The unit is not exposed to rain or moisture.
—The unit is not exposed to excessive dust or dirt.
—The unit is not subject to excessive vibration.
—The fuel tank should not be damaged by the tapping screws.
—There should be no wire harnesses or pipes under the place where you are going to install the unit.
—The spare tire, tools or other equipment in or under the trunk should not be interfered with or damaged by the screws or the unit itself.
•Be sure to use only the supplied mounting hardware for a safe and secure installation.
•Use only the supplied screws.
Installing the unit
•Mount the unit either inside the trunk or under a seat.
•Choose the mounting location carefully so the unit will not interfere with the normal movements of the driver and it will not be exposed to direct sunlight or hot air from the heater.
•Do not install the unit under the floor carpet, where the heat dissipation from the unit will be considerably impaired.
Connection
Connection example
XM Antenna* |
| Sony BUS Compatible |
| Car Audio* | |
|
| |
|
|
|
CD/MD changer*
* not supplied
Connection diagram
First, place the unit where you plan to install it, and mark the positions of the four screw holes on the mounting surface.
11
Screw hole: ø3.3 mm (5/32 in.)
XM Radio ID number seal
(XM ID XXXXXXXX)
Notes
•Use only the supplied screws.
•Be sure not to damage the fuel tank or brake line with the tapping screws.
Fuse replacement
Connect with a BUS cable to the XM Satellite receiver, aligning the v marks.
Note
When you use an optional BUS cable, note that a BUS cable with an
SONY BUS
POWEROUT
2
Connect with the connector hook facing down.
If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction.
Warning
Use a fuse with the specified amperage rating.
Use of a higher amperage fuse may cause serious damage.
To a +12 V power terminal which is energized at all times
Be sure to connect the black ground lead to it first.
To a metal point on the car
First connect the black ground lead, then connect the yellow power input leads.
Fuse (3 A)
Yellow
Black
Note
Locate the power cord and the RCA pin cord as far away as possible.