Control elements
Power |
|
| This LED indicates that the GainStation 1 is connected to the |
| proper AC current and switched on. If the tube stage is active |
| when the unit is switched on, it can take several seconds before |
| a signal can be |
| reach operating temperature. |
| LED Level Display |
| The level display shows the peak level before output level |
| control. A special circuit allows the LED‘s to vary in brightness |
| to display |
| |
| nates weakly at 0 dB and reaches full brightness at +9 dB and so |
| on. |
| The CLIP LED operates |
| clipping at this point in the signal path. It will not react to tube |
| saturation in the tube stage, since this can be a desired effect. |
AD OVL | AD OVL |
| This LED displays clipping in the internal AD converter and |
| illuminates at approximately 0.5 dB before 0 dBfs. This LED |
| should never illuminate when using the internal or an external |
| |
| ingly. |
| If the converter is not being used or not installed, the AD IN 1 |
| MUTE switch should be activated, so that the output signal is no |
| longer routed to the converter and the AD OVL circuit. Signals |
| connected to AD IN 2 are also displayed by the AD OVL LED and |
| cannot be switched off (they can only be disconnected). |
18 | GainStation 1 |