Parametric
Fig. 4:
The NOTCH curves on the 0dB line are shown for Q0.6. On the outside, the curve is shown for GENTLE
The NOTCH curves on the
Fig. 5:
Three NOTCH curves with STEEP
ristics can be altered from GENTLE to STEEP, (also see point 9: BOOST/CUT , page 16).
Important: If you switch on the NOTCH mode, the bandwidth control Q must be set at 0.6 (extreme right), so as to ensure a 1:1 level ratio with the original signal.
Narrower notches can be obtained if the Q control is turned to the extreme left. However, then the output level is also reduced by around 20dB.
Figure 4 shows the curves for the NOTCH with GENTLE and STEEP characte- ristics at Q0.6, along with the same curves at Q3.6.
18