Filters prevent dust from accumulating on the optical elements inside the projector. Should the filters become clogged with dust particles, it will reduce cooling fans’ effectiveness and may result in internal heat buildup and adversely affect the life of the projector. If a “Filter warning” icon appears on the screen, clean the filters immediately. Clean the filters by following the steps below.
1 | Turn off the projector, and unplug the AC power cord |
| from the AC outlet. |
2 | Turn the projector over and remove the filters by |
| pulling the latches upward. |
3 | Gently clean the filters by using a brush or rinse them |
| softly. |
4 | When rinsing the filters, dry them well. Replace the |
filters properly. Make sure that the filters are fully inserted to the projector.
CAUTION
Do not operate the projector with the filters removed. Dust may accumulate on the optical elements degrading picture quality.
Do not put anything into the air vents. Doing so may result in malfunction of the projector.
RECOMMENDATIONWe recommend avoiding dusty/smoky environments when you operate the projector. Usage in these environments may cause poor image quality.
When using the projector under dusty or smoky conditions, dust may accumulate on a lens, LCD panels, or optical elements inside the projector degrading the quality of a projected image. When the symptoms above are noticed, contact your authorized dealer or service station for proper cleaning.
Filters
Pull up and remove.
✔Note:
•When reinserting these filters, be sure that the slit part is facing the outer side.
Be sure to reset the Filter counter after cleaning or replacing the filters.
1 | Press the MENU button to display the | Filter counter |
| Menu. Use the Point 78 buttons to move the red |
|
| frame pointer to the Setting Menu icon. |
|
2 | Use the Point ed buttons to move the red frame |
|
| pointer to Filter counter and then press the SELECT |
|
| button. A dialog box appears showing the total |
|
| accumulated time of the filter use, a timer setting |
|
| option, and the reset option. Select Reset and the |
|
| “Filter counter Reset?” appears. Select [Yes] to |
|
| continue. |
|
3 | Another confirmation dialog box appears, select [Yes] |
|
| to reset the Filter counter. |
|
Select Reset and the “Filter counter Reset?” appears.
Select [Yes], then another confirmation box appears.
Select [Yes] again to reset the Filter counter.
57