SoundCraft MFX Power Indicator, Phantom Power, Track Level Control, Track to MIX, Mix, Sub

1 POWER INDICATOR

This LED lights to show when power is connected to the console.

2 PHANTOM POWER

Many professional condenser mics need PHANTOM POWER, which is a method of sending a powering voltage down the same wires as the mic signal. Press the switch to enable the +48V power to all of the MIC inputs. The adjacent LED illuminates when the power is active.

WARNING: TAKE CARE when using unbalanced mics which may be damaged by the phantom power voltage. Balanced dynamic mics can normally be used with phantom power switched on (contact your microphone manufacturer for guidance).

Mics should always be plugged in, and all output faders set to minimum before switching the Phantom Power ON to avoid damage to external equipment.

2-TRACK

3 2-TRACK IN

These two RCA phono sockets are unbalanced Left and Right line-level inputs, used for connecting a play- back device.

4 2-TRACK LEVEL CONTROL

This adjusts the signal level from the 2-Track inputs.

5 2-TRACK TO MIX

Press this switch to route the 2 Track input signals to the MIX Left/Right signals at the MIX outputs.

MONITOR SOURCE

The following three switches select the signal source(s) to be monitored. More than one can be selected at a time.

6 MIX

Press this switch to monitor the main mix outputs.

7 SUB

Press this switch to monitor the sub-group (L & R) outputs.

8 2-TRACK

Press this switch to monitor the 2-Track input signal.

MONITOR OUT

9 MONITOR OUTPUT LEVEL

This control sets the signal level fed to the MONITOR LEFT & RIGHT outputs.

10 MONITOR OUTPUTS

The Monitor Outputs are on 3-pole 6.35mm (1/4") jacks and are balanced.

11 HEADPHONES LEVEL

This control sets the level of the Headphone output.

21