PROTECTION ClRCUITRY
Your SA amplifier is protected against both overheating and short circuits by means of the following circuits:
•Main power supply fuses.
•Speaker output circuit breakers.
•A
NOTE: If you experience blown main power supply fuses, DO NOT increase values beyond the original values! Doing so will void your warranty and may damage your amplifier.
TROUBLESHOOTlNG
| PROBLEM |
| CAUSE |
|
|
|
|
| No sound and LED is not lit |
| 9 no power or ground at amp |
|
|
| 0 no remote |
|
| • blown fuse near battery | |
|
|
| • blown amp power supply fuse |
|
|
|
|
| Repeatedly blown amp fuse, |
| • check speaker configuration- |
| frequent activation of Thermal |
| impedance may be less than 2 |
| Protection Circuit | ~ ohms stereo or 4 ohms mono | |
|
| I • speaker or leads may be shorted | |
|
|
| • verify adequate amplifier |
|
|
| ventilation |
|
|
|
|
| No sound from channels 3 & 4 with |
| • check input settings on bottom Of |
| 2 channels of input |
| |
|
|
| internal inputs “1& 2” |
|
|
|
|
SERVICE
Your Soundstream amplifier is protected by a limited warranty. Please read the enclosed warranty card.
SPECIFICA TIONS
.
|
| I | Power |
| Power |
| Bridged Power |
|
|
| 4 ohms |
| 2 ohms |
| 4 ohms | I | |
I | SA.80 |
| 40~x2 |
| 60~x2 | I | 12Owxl |
|
I | / |
| I | |||||
| SA* 164 |
| 4owx4 |
| 60~x4 |
| 12owx2 |
|
|
|
|
|
|
|
|
|
|
THD | < 0.1% |
Signal to Noise | > 100 dB |
Frequency Response 20 Hz to 20 kHz +I- 0.5 dB
Stereo Separation >90dB
Damping | > 200 |
Input Sensitivity | 100 mV - 2.5 V |
Input Impedance 12 k ohms
CROSSOVER SPECIFICATIONS
High Pass: 12 dB/octave, 150 Hz
Low Pass: 12 dB/octave, 75 Hz
DIMENSIONS
SA*80:
SA*164:
18 | 1 9 |