3-3 Battery removal
180˚
Put up the Belt clip hole turning 180 degree.
1
2
After putting up the belt clip, remove the battery holding it up as shown above.
3-4 Battery charging
Lamp
1.Be sure that the printer is turned off
2.After open the DC JACK cover, insert DC JACK into the printer.
3.Plug the power code to electrical outlet.
Status | charging | charging complete |
Charging Lamp | Red | Green |
|
|
|
NOTE
1.Unless the exclusive charger is used provided by the manufacturer, the printer can be damaged, and the manufacturer is not liable for the consequential damage.
2.Before removing the battery, make sure that power is turned off.
3.Printer does not work in the status of being connected with charger only.
4.The battery should be installed to operate printer.
5.While charging, do not turn on the power.
6.Do not operate the print while charging the battery.
7.Do not connect the charger while the printer is operated.
6 | 7 |
