SpeakerCraft BassX-W10 owner manual Installation of BBXW10

BassX-W10 Owner’s Manual	Page 7
2. Installation of BBXW10
Please use Diagram 2 to familiarize yourself with the rear panel of the BBXW10.

Serial Number

Phase Switch

DIAGRAM 2
BBXW10 Rear Panel
Power Switch	Fuse

		Low Pass
Speaker Outputs		Crossover
	Line	Control
Speaker Inputs	Outputs	LFE Input

Line Inputs

Bass
Boost	Subwoofer
Control
	Outputs

Volume Limit

Control

AC Plug Cord

a. Auto Sense Power On

•The amplifier is turned on and off by sensing audio signals coming from the receiver or pre-amp through the input connections.

•NOTE: The amplifier’s front power switch must be turned on for the Audio Sense mode to operate. Once the power is switched on, the auto sense mode automatically is activated. The “Active” LED on the front of the amplifier will not light up until an audio signal is sensed. The amplifier will then be operating. At the moment that either the Left, Right line level input jacks, the speaker input connectors or the LFE input jack receive a signal, the amplifier will then turn on. Once the signal stops, the amplifier will turns off in a few minutes. If you will be away for a long period of time, you may wish to turn off the main power switch or unplug the unit from the outlet.

b.Connecting the Subwoofer to the Amplifier

•CAUTION: Only make connections when the amplifier is turned off.

•You MUST use a minimum of 14 gauge speaker wire. There are 2 outputs on the amplifier, one positive and one negative outputs. The 3-way binding post outputs on the back of the amplifier allow for a variety of ways to connect your subwoofer to the amplifier, including stripped wire, spade connectors, etc.