SpeakerCraft ERS-1.0 owner manual System Setup, Router Setup, MZC Setup, RSA Setup

2.The Wireless Network Connection window should appear and you should see your wireless network listed with the network name you chose. If you don’t see your network, click Refresh network list in the upper-left corner. Click your network, and then click Connect in the lower-right corner.

3.Windows XP prompts you to enter a key. Type the encryption key that you wrote down earlier in both the Network key and Confirm network key boxes, and then click Connect.

4.Windows XP will show its progress as it connects to your network. After you’re connected, you can now close the Wireless Network Connection window. You’re done.

Note: If the Wireless Network Connection window continues to show Acquiring Network Address, you may have mistyped the encryption key.

SYSTEM SETUP

Step 1 - ROUTER SETUP

In this scenario, we will use a Linksys wireless router. Default setting for a Linksys Router is 192.168.1.1. With a computer con- nected to the wireless router and all related equipment powered up, open up the internet browser on your computer and type in 192.168.1.1 and press ENTER. Log in window will appear. Enter the default user name and password for the Linksys router (default is admin/admin). See Figure 1. Default static IP setting for the ERS-1.0 is xxx.xxx.x.254. The default setting on the Linksys router does not need to be changed to accommodate the ERS-1.0’s IP address. Save settings and power down the router.

Other manufacturers might need to have their settings adjusted to be sure there are no IP address conflicts on the network. Configurations will vary for this set up, please make sure to read the router’s owner’s manual for details.

NOTE: The DHCP address range for the router must not include xxx.xxx.x.254 or there could be potential IP conflicts on the system with dynamic devices.

Figure 1

Step 2 - MZC SETUP

Download your project and the latest firmware to the MZC. For information on creating an EZ Tools project and downloading firmware, please refer to the EZ Tools Programming Guide.

There is no special setup in the EZ Tools software for the ERS interface, however, there are buttons on the GUI interface that do relate to the project (keep this in mind when programming). See Page 7 for call outs on GUI buttons.

Step 3 - RSA SETUP

Download the "MZC Control Firmware" into the RSA please refer to the EZ Tools Programming guide for details.

4