Page 2 | Starlet Owner’s Manual |
GETTING STARTED
Your Starlet 4, 6 or 9 speakers are individually packed with the following:
•Back Box/Driver Assembly
•Bezel/Flange Assembly
•Cardboard
•Accessory Pack (See Diagram 1)
•Outer Bracket
•Inner Bracket
•Foam Support Block
•Screws: Two M4 x 20mm for Outer/Inner Bracket Two Hex Head M4 x 45mm Screws per Driver
(8 for Starlet 4, 12 for Starlet 6 and 18 for Starlet 9)
•3mm Hex Head M4 Driver Bit (for electric screwdriver)
Also available separately for the Starlets 6 and 9:
•
•ASM89000: Complete Kit with Test CD and Analog Voltmeter with Leads
•ASM89001: Test CD Only
For installation of your Starlets, you will need the following:
• Stud Finding Tool | • Masking tape or tacks (for template) |
• Drywall Saw | • Level |
• Electric Screwdriver | • Wire Strippers |
• Hand Screwdriver with #2 Phillips Head | • Utility Knife |
• Pencil (for marking wall) | • Tape Measure |
Amplifier Requirements:
•Starlet 4: Minimum 75 watts per channel stereo amplifier with low impedance capability (i.e. SpeakerCraft BB275)
•Starlets 6 and 9: Two (2) minimum 75 watts per channel stereo amplifiers with low impedance capability and individual level controls on each channel
•The SpeakerCraft BB275 is a good starting point for all 3 models of the Starlet
Diagram 1:
Accessory Pack