Specialized Cyclocomputer Programming, Setting the Programmable Odometer, Easy Calibration Mode

Programming:

Programming the functions of your SpeedZone® Team requires it to be placed in various “modes” (i.e. odometer mode, distance mode). The computer can be cycled through these modes by pressing the “MODE” button located on the right-hand side of the housing. Once a specific mode has been entered, its values can be reset or adjusted by pressing either the “FUNC- TION” button located on the left hand side of the housing or by using a combination of the “MODE” and “FUNCTION” buttons.

1.Miles or Kilometers selection: Your SpeedZone® Team will record speed and distance in either miles (M/h) or kilo- meters (KM/h). To enter your selection of miles or kilometers, push the “MODE” but- ton until ODO (odometer) appears in the lower left side of the display (This is called the odometer mode). Hold down the “FUNCTION” (left side) button and ‘tap’ the “MODE” button once. The Km/h, m/h indi- cator will begin blinking. You may now

4

alternate between miles and kilometers by pressing the “MODE” button. When the correct choice is flashing, select it by press- ing the “FUNCTION” button. You will now enter the “Programmable Odometer” mode. If the odometer setting is correct push the “FUNCTION” button (5 times) to exit to odometer mode (otherwise, see “Setting the programmable odometer below).

2. Setting the

Programmable

Odometer:

The programmable odometer mode is accessed by enter-

ing the odometer (ODO) mode and holding down the “FUNCTION” button and ‘tap- ping’ the “MODE” button once. The Km/h indicator will flash. If the Km/h setting is correct press the “FUNCTION” button once and a five digit number will appear. You are now in the programmable odometer mode. This mode is useful if you have replaced the battery and would like to

retain the mileage you have already rid- den. To enter a mileage into the odometer, press the “MODE” button until the flashing digit is correct. (Note: The “MODE” button may be held to scroll to the correct digit.) Press the “FUNCTION” button to select the next digit to the right. Repeat the process until all five digits are entered as your exist- ing mileage.

3.Wheel Circumference Selection: To set the circumference for the type of tires you are using, you can use Specialized’s exclusive “Easy Calibration Mode” or mea- sure your actual tire circumference by the roll-out method. Two different tire diameters may be entered into the computer’s “Second Wheel Option.”

Easy Calibration Mode:

Your SpeedZone® Team has been prepro- grammed with the following 14 Specialized tire sizes:

•26 X 1.0	•26 X 1.25	•26 X 1.5
•26 X 1.75	•26 X 1.9	•26 X 2.0

•26 X 2.1	•26 X 2.2	•650 X 20
•700c X 20	•700c X 23	•700c X 26
•700c X 32	•700c X 38

When using Easy Calibration Mode, the

SpeedZone® will dis-
play the tire size on
it’s LCD display
screen. (see figure 6)
The Easy Calibration
Mode is accessed by	fig.6
entering the odometer (ODO)
mode and holding down the

“FUNCTION” button for three seconds. The display will now show the currently selected tire size for wheel option #1.

To scroll through the preprogrammed tire sizes tap both the “MODE” and “FUNC- TION” buttons simultaneously. When you reach the desired tire size press the “FUNCTION” button once to select it and enter Easy Calibration Mode for wheel option #2. Follow the same procedure to program the wheel #2 tire size and tap the “FUNCTION” button to exit to odometer

mode.5