To Change Cycles
If the selected cycle is not the correct cycle for the fabric being washed, you may change the cycle selection at any time until the first wash fill is complete. Once the washer has filled for the first part of the cycle (the wash portion), the current cycle must be aborted and a new cycle must be started.
To change the cycle before the first fill is complete:
Change the cycle selected on the cycle selector knob.
To change the cycle after the first fill is complete and before the first wash is complete:
1.Abort the current cycle by changing the cycle selector knob to the OFF position.
2.Set the WASH/RINSE temperature selector.
3.Set cycle selector knob.
4.Turn on extra rinse, if desired.
5.Press and hold the START button for two seconds.
To change the cycle after the first wash is complete:
NOTE: This should only be done if the speed of the final extract is incorrect for the fabric being washed. For example, if washing delicate items on the REGULAR cycle, the high speed extract may damage the fabric. Or, if washing towels or jeans on the DELICATE cycle, the lower speed extract would increase drying time.
1.Abort the current cycle by changing the cycle selector switch to the OFF position.
2.Restart the cycle from the beginning. Refer to the To Wash Clothes section.
To Pump Out Water After Aborting Cycle
Run a SPIN ONLY cycle. This cycle will perform a high speed extract operation that will pump all of the water out of the washer.
Manual Soaking
To soak a clothes load, start a wash in the desired cycle. After fill is complete and wash drum has started tumbling, turn the cycle selector knob to OFF. When the clothes have soaked the desired length of time, turn the cycle selector knob to the cycle and press the start button to restart the cycle.
DOOR Light
When the washer is started, the DOOR light will come on after a short delay. The light will turn off approximately 45 seconds after the cycle is complete.
WASH Light
This light comes on during the wash part of each cycle.
RINSE Light
This light comes on for the rinse portion of each cycle.
FINAL SPIN Light
This light comes on while the wash load is in the final spin of the cycle.
HEATING Light (Red Light – on select models only)
This light comes on during the Boosted Hot setting only. While the washer is heating, the HEATING light will turn on.
Out of Balance Load
If at the end of the cycle, the load is dripping wet, the washer has limited the spin speed. This is to prevent damage to the unit if there is a severely unbalanced load.
If this condition occurs, redistribute the load manually and run a RINSE & SPIN cycle.
If the condition persists, consider steps discussed in the Before Washing section.
802759