Vacations and Extended
•To avoid possible property damage due to flooding, turn off the water supply to the washer whenever there will be an extended period of
Reinstallation of Shipping Materials
To prevent damage while moving the unit, the shipping materials MUST be reinstalled.
•Disconnect washer from electrical supply.
•While supporting the front access panel, remove two screws from the bottom edge of the panel.
•Gently lower the panel to remove it from the washer.
•Place the shock sleeves on all four shock absorbers. Refer to the illustration below.
•Insert hooked end of shipping brace into the open slot of the motor mount.
•Attach the brace with the five bolts and washers. Refer to the illustration below.
•Reinstall front access panel.
Shock
Sleeves
Motor
Mount
Hooked End of
Shipping Brace
Refer to the INSTALLATION INSTRUCTIONS for proper procedures whenever the washer is moved.
Cleaning Foreign Object Trap
The washer’s pump has a trap that may collect foreign objects. The trap may need to be cleaned if water is draining slower than usual. To clean:
•Disconnect washer from electrical supply.
•While supporting the front access panel, remove two screws from the bottom edge of the panel.
•Gently lower the panel to remove it from the washer.
NOTE: The pump may have some water in it. Use a rag or a container to catch water. If the wash drum is full of water, use a wet/dry shop vacuum to catch the water.
•With rag or vacuum ready, unscrew the cap on the left side of the pump and remove trap.
•Clean the debris from the trap.
•Reinstall the trap and access panel.
•Reconnect washer to electrical supply.
FLW2182N
Bolts and Lockwashers
FLW2182N
802759