Maintenance
Lubrication
All moving parts are sealed in a permanent supply of lubricant or are equipped with oilless bearings. Additional lubrication will not be necessary.
Care of Your Dryer
WA R N I N G
To reduce the risk of an electric shock, serious injury or death, disconnect the electrical service to the dryer before cleaning the interior.
W132
Dryer Interior
Wipe the surfaces using a soft cloth and household cleaner or a
To remove crayon or ball point ink off the dryer drum, put the heat on high and use old rags in the dryer to absorb the crayon or ink. If unsuccessful, contact the appliance dealer. DO NOT use any chemicals in the dryer.
IMPORTANT: The use of chlorine bleach for removing any discolorations should be avoided because bleach could damage the finish.
Cabinet
Wipe the dryer cabinet as needed. If detergent, bleach or other washing products have been spilled on the dryer, wipe immediately. Some products will cause permanent damage if spilled on the cabinet.
Control Panel
Use only a damp or sudsy cloth for cleaning the control panel. Some spray pretreat products may harm the finish on the control panel.
NOTE: The wiring diagram is located inside the control panel.
Exhaust System
WA R N I N G
To reduce the risk of electric shock, disconnect the electrical service to the dryer before cleaning.
W043
The exhaust duct should be inspected after one year of use and cleaned if necessary by a qualified service person.The exhaust duct should be inspected and cleaned every one to two years as required thereafter. Every two years a qualified service person should remove all front panels and vacuum the inside of the dryer.
NOTE: This recommended maintenance is not covered under the terms of the warranty.
The weather hood should be checked frequently to make sure the dampers move freely, dampers are not pushed in and that nothing has been set against them.
Keep dryer area clear and free from combustible materials, gasoline and other flammable vapors and liquids.
Do not obstruct the flow of combustion and ventilation air.
NOTE: Verify proper operation after servicing.
Motor Overload Protector
The dryer’s motor overload protector stops the motor automatically in the event of an overload. After cooling, the overload protector will reset itself. Dryer can be restarted by pushing the timer knob in. If overload protector cycles again, remove the dryer from use and call the service person to correct the problem.
513218
© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
