Assembly Instructions
UNPACKING THE UNIT
1.Using a razor knife (Box Cutter) cut the outside, bottom, edge of box along the dotted Line. Lift Box over the unit and unpack.
2.Carefully remove all parts from carton and inspect for any damage or missing parts. If damaged parts are found, or parts are missing, contact your dealer immediately.
3.Locate the hardware package. The hardware is separated into steps. Remove the tools first. Remove the hardware for each step as needed to avoid confusion.
STEP 1: REAR RAIL ASSEMBLY
1.Remove the hardware from the hardware pack for step 1. You should have four
2.Put the two flat washers on the
3.Put the four curved washers on the
4.Using the wrench provided tighten all six bolts securely.
5.Locate the four plastic covers (XE150, XE350 only) for the rear rail assembly and the one cover for the front stabilizer and install them using the six 5/8 X 1/4 screws and the Phillips head screw driver provided.
STEP 2: CONSOLE MAST ASSEMBLY
1.Remove the hardware from the hardware pack for step 2. You should have one
2.Locate the console mast and console mast cover and slide the cover onto the mast as far as it will go. Make sure the cover is facing the correct way.
3.At the top opening of the main body of the elliptical is a wire harness. Unravel and straighten out the wire harness and feed it into the bottom of the console mast tube and out of the top opening.
4.Install the console mast into the receiving bracket in the top of the main body. NOTE: there is one bolt already installed in the receiving bracket that will engage with the slot at the bottom of the console mast. This needs to be tightened at the end along with the three other console mast bolts.
11 | EL3 /EL5 Elliptical |
|
