•Exiting Radio

To leave the radio sub menu, press either the "Select" button or the "Menu" button once.

2.6.Voice

The SPIRIT has an integral voice record capability.

•Voice: Recording voice

There are two ways to record voice on the SPIRIT digital audio player. These are:

a)By activating the switch on the microphone built into the ear bud speakers and the recording will be from the microphone in the ear bud.

b)By activating, the record button and the recording will be from the microphone built directly into the device.

The voice record buttons on the unit and the ear bud speakers both operate in a toggle mode. Press these buttons to activate recording and press again to stop recording. The player will then store the recording in the Recordings list and resume operation from its state before record was initiated.

•Voice: Replaying voice recordings

Select Voice from the top-level menu and select “Recordings …”. using the “Navigate Up” and the “Navigate Down” buttons and pressing “Select”. This will display a list of recordings stored on the player. Use the “Navigate Up” and the “Navigate Down” buttons to select the recording. To replay the recorded message, press the “Select” button. During re-play, you can press “Select” to leave the recording and skip back to previous menu. Use the “Menu” button to get back to the top-level menu.

2.7.Settings

The settings menu contains the adjustable settings for the player and allows you to customise your SPIRIT mode of operation.

2.7.1Backlight

The SPIRIT has a backlight for the display, which helps viewing in poor lighting conditions. Selecting “Backlight” toggles the backlight on and off.

2.7.2Equalizer

The SPIRIT has preset equalization settings and a built in graphic equalizer. The graphic equalizer allows you to adjust the signal strength of different portions of the audio spectrum (frequencies) so that you can get "equal" performance across the audible spectrum. A graphic equalizer divides the entire spectrum into pieces. This lets you set the signal strength for a specific frequency section (called bands) and lets you adjust the strength (volume) of each band up or down from the original signal.

Select “Settings Equalizer Graphic EQ” to customize the equalizer settings to your own preference. Use the “Skip Forward “ and the “Skip Back” buttons to select a frequency range and adjust the level using the “Navigate Up” and “Navigate Down” buttons. Press “Select” to leave the graphic equalizer. These settings will be preserved until they are next changed. Alternatively, select “Settings Equalizer” and

 

 

 

SPIRITMAN060104

Entempo 14