STEP2:Console Mast
1.Slide the Computer Cable (44) and Hand pulse Wire (133) through the bottom of the Console Mast Cover (31) and then the bottom of the Console Mast (2). Make sure the Console Mast Cover is correctly oriented (see illustration).
2.Install the Console Mast (2) into the receiving tube (make sure not to pinch cables (44) and (133); damage to the electronics could occur) of the Main Frame (1). Insert two Hex Head Bolts (68) and two Flat Washers (76) on each side. Insert two Hex Head Bolts and two Curved Washers (83) on the front.Tighten all six bolts firmly with the wrench (112).
3.Remove the white Styrofoam pad (factory installed to prevent bolts from being accidentally dropped into the console mast tube).
4.Attach the Handle Bar Assembly (3) onto the Console Mast (2) bracket with the two Hex Head Bolts (68), two Split Washers (82), and two Flat Washers (76). Completely tighten with the wrench (112).
HARDWARE
#82. 8 x 1.5T | #83. 5/16” x 19 x 1.5T | #68. 5/16” x 15mm Hex |
Split Washer | Curved Washer | Head Bolt |
(2 pcs) | (2 pcs) | (8 pcs) |
XBR25 Fitness Bike |
| 6 |
#76. 5/16” x 18 x 1.5T
Flat Washer
(6 pcs)
