BELT/DECK LUBRICATION PROCEDURE

Do not lubricate with other than Spirit approved lubricant. Your treadmill comes with one tube of lubricant and extra tubes can be ordered directly from Spirit or your authorized Spirit dealer.

There are commercially available lube kits, but the only one

currently approved by Spirit is Lube-N-Walk.

These kits come with an application wand that makes applying the lubrication easier. The kits can be purchased directly from Lube-N-Walk here: http://www.jadfitness.com/. The proper kit

should be silicon based, NOT paraffin wax.

Keeping the deck lubricated at the recommended intervals ensures the longest life possible for your treadmill. If the lubricant dries out, the friction between the belt and deck rises and places undue stress on the drive motor, drive belt and electronic motor control board, which could result in catastrophic failure of these expensive components. Failure to lubricate the deck at regular intervals may void the warranty.

The belt & deck come pre-lubricated and subsequent lubrication should be

performed every 180 hours of use. The console has a built in lubrication reminder indicator that lights every 180 hours of use.

Use the Lubricant to lubricate the deck beneath the belt. If you can reach under the belt approximately 6” on each side, use the following procedure: Unplug the electrical cord. Towards the middle of the deck (about 18” from the edge of the motor cover), lift up on the belt and reach under with the tube of lubricant. Squirt half of the lubricant on the deck surface in a line (parallel to the motor cover) spanning the 6”. Repeat the process on the opposite side. Plug the electrical cord back into the outlet and walk on the belt at a moderate speed for five minutes.

If unable to perform the above procedure, it will be necessary to loosen the walking belt. Using the 6 mm Allen wrench supplied, loosen the two rear roller adjustment bolts -- located in the rear end caps – enough to get your hand under the belt (5 –10 turns). Make sure to loosen both bolts the same amount of turns and also remember how many turns, because when finished you will need to tighten the bolts back to the point they were before.

Once the belt is loose, wipe the deck with a clean lint free cloth to remove any dirt. Apply the whole tube of lubricant onto the deck surface about 18 inches from the motor cover. Squeeze out the contents of the tube across the deck (parallel to the motor cover) in about a one-foot line, like toothpaste on a toothbrush. The one-foot line should be in the middle of the deck at approximately equal distance from both side edges of the belt. You want the lubricant to be applied about the spot that your feet would hit the belt as you are walking. This should be about 18 inches from the motor cover, but you may want to walk on the treadmill before loosening the belt to note where your feet land on the belt. If you mostly use the treadmill for running, the spot where your feet land may be different from walking.

Once the lubricant is applied, tighten the rear roller bolts the same amount of turns as when you loosened them. Run the treadmill at about 3 mph without walking on it for about a minute or two to make sure the belt stays in the middle of the deck. If the belt tracks to one side then follow the belt tracking instructions to remedy. Now the deck is lubricated and you should walk, not run, on the treadmill immediately for at least 5 minutes to ensure the lubricant is evenly distributed. If you purchase a silicone based Lube-N-Walk kit, follow the instructions that come with it to apply the lubrication.

XT185 Treadmill

22

Page 23 Page 25
Page 24
Image 24
Spirit XT185 owner manual BELT/DECK Lubrication Procedure
Page 23 Page 25

XT185 specifications

The Spirit XT185 is a premium piece of fitness equipment designed to bring gym-quality workouts into the comfort of your home. This elliptical machine combines a sleek design with robust functionalities, making it an excellent choice for fitness enthusiasts of all levels.

One of the standout features of the Spirit XT185 is its ergonomic design, which ensures a comfortable and natural stride. With a 20-inch stride length, users can enjoy an efficient workout without putting undue stress on their joints. This is particularly beneficial for those who are recovering from injuries or are new to exercising.

The XT185 is equipped with a large, easy-to-read LCD display that provides real-time feedback on essential workout metrics. Users can track their heart rate, calories burned, distance, time, and resistance levels, making it easy to monitor their progress. The heart rate monitoring can be done through built-in sensors in the stationary handlebars, ensuring users stay within their target heart rate zones for optimal cardiovascular benefits.

This elliptical machine features 16 levels of resistance, allowing users to customize their workouts according to their fitness levels and goals. Whether you are looking for a challenging high-intensity session or a low-impact workout, the Spirit XT185 can deliver modes that cater to your needs. The smooth, silent operation of the machine is made possible by its high-quality, durable components, which ensures long-lasting performance.

Adding to its versatility is the built-in workout programs. The XT185 offers various pre-set programs designed to enhance different aspects of fitness, such as fat burning, cardio conditioning, and hill training. This variety keeps workouts engaging and can significantly aid users in achieving their health and fitness objectives.

Finally, the Spirit XT185 promotes a compact and space-saving design, making it suitable for homes with limited workout space. Its transportation wheels facilitate easy movement and storage, allowing users to make the most of their exercise areas. With its combination of advanced features, sturdy construction, and user-friendly design, the Spirit XT185 is a valuable addition to any home gym setup for anyone looking to improve their fitness journey.
Top Page Image Contents