Spirit XT485 owner manual Service Checklist - Diagnosis Guide, Problem, Solution/Cause

SERVICE CHECKLIST - DIAGNOSIS GUIDE

Before contacting your dealer for aid, please review the following information. It may save you both time and expense. This list includes common problems that may not be covered under the treadmill’s warranty.

PROBLEM	SOLUTION/CAUSE
Display does not light	1. Tether cord not in position.
	2. Circuit breaker on front grill tripped.
	Push circuit breaker in until it locks.
	3. Plug is disconnected. Make sure plug is firmly
	pushed into AC household wall outlet.
	4. Household circuit breaker may be tripped.
	5. Treadmill defect. Contact your SPIRIT dealer.
Tread-belt does not stay centered	The user may be walking while favoring or putting
Treadmill belt hesitates when	more weight on either the left or right foot. If this
walked/run on	walking pattern is natural, track the belt slightly
	off-center to the side opposite from the belt
	movement. See General Maintenance section on
	Tread-belt Tension. Adjust as necessary.
Motor is not responsive after	1. If the belt moves, but stops after a short time
pressing start	and thedisplay shows “LS”, run calibration.
	2. If you press start and the belt never moves,
	then the display shows LS, contact service.
Treadmill will only achieve	This indicates motor should be receiving power to
approximately 7 mph but shows	operate. Low AC voltage to treadmill. Do not use
higher speed on display	an extension cord. If an extension cord is required
	it should be as short as possible and heavy duty
	16 gauge minimum. Low household voltage.
	Contact an electrician or your SPIRIT dealer. A
	minimum of 110 volt AC current is required.
Tread-belt stops quickly/suddenly	High belt/deck friction. See General Maintenance
when tether cord is pulled	section on lubrication.
Treadmill trips on board 15 amp circuit	High belt/deck friction. See General Maintenance
Computer shuts off when console is	Treadmill may not be grounded. Static electricity is
touched (on a cold day) while	“crashing” the computer. Refer to Grounding
walking/running	Instructions on page 3.
House circuit breaker trips, but not	Need to replace the house breaker with a “High In-
the treadmill circuit breaker	rush current” type breaker (see page 3 for details)

31 XT485 Treadmill