Sportline SOLO 900 manual

Be sure to activate the Heart Rate mode by pressing the bottom metal sensor so that the display flashes. It is best to use the flat ‘pads’ of your finger, and not the fingertips.

3.A ‘beep’ will sound and your heart rate will be displayed. It’s that easy!

Because the Sportline Solo 900 Heart Rate Watch is a sensitive monitoring device that reads your EKG signals, reading times will vary. If you don’t get a reading in 3-8 seconds, wait a couple of minutes and try again. This gives the Sportline Solo 900 Heart Rate Watch a chance to settle in and pick up your electrical signals.

Your heart rate will remain displayed once measured, and will remain displayed for 7 seconds after you release the sensor button.

•The Sportline Solo 900 Heart Rate Watch must be attached to your wrist in order for the Heart Rate Measure function to work.

•Proper finger pad contact is very important and affects the heart rate reading time.

•For those users with dry skin, thick or calloused finger, low heart rate signal strength (EKG strength), minimal padding

on your finger, or users located in dry environments, please see our Helpful Hints section.

•The Heart Rate Measure function is not intended for use or operation in or under water.