Recold / JT Series CoolingTower / Accessories
4
CAPACITY CONTROLS
Dual Fan
Variable Speed
Electric Damper
CASING INSULATION
In order to further reduce the heat loss from the unit coil, factory installed insulation on exterior coil panels is available. A protective coat of paint is applied to the insulation for protection from the weather elements.
CONTROL – STARTER PANEL
Contains the fan motor starter, disconnect switch, thermostat sensing the cold water temperature to control the fan motor and control transformer when required by the supply power characteristics. All components are contained in a NEMA 12 enclosure with UL label and mounted on the unit. Fan motor and controls are factory wired to the panel to provide single point connection for users power supply.
Panels for dual
VIBRATION ISOLATORS
Spring type vibration isolator rails may be supplied for field
ELECTRONIC WATER LEVEL CONTROL
The electronic water level control package provides a constant and accurate means of monitoring water level in the unit. For this reason, it is often recommended for those installations which require year round operation in low ambient conditions.
The complete package includes an electric float switch with stilling chamber which is factory installed in the pan section of the unit. An electric solenoid valve for water
is shipped loose for remote installation. All wiring must be provided in the field by others.
PAN HEATER
The use of a remote sump tank located indoors is a common form of pan water freeze protection for evaporative cooling equipment. However, for those installations which will not allow this type of system, freeze protection may be provided by electric immersion heaters or steam or hot water coils installed in the pan.
The electric heater package consists of immersion heaters installed in the pan to provide efficient even heat distribution. Standard heaters are selected to provide approximately 40°F pan water at
NOTE: Pan heater packages are designed to prevent pan water freezing during unit shutdown with fans and pump idle.
STAINLESS STEEL CONSTRUCTION
In addition to the standard stainless steel basin, fill supports and access doors, 300 stainless steel construction is offered as an option for upper casing panels.
RECOLD PRODUCTS
550 W MERCURY LANE BREA, CALIFORNIA 92821 UNITED STATES
704 529 6080 spxcooling@spx.com spxcooling.com
In the interest of technological progress, all products are subject to design and/or material change without notice.
©2008 SPX Cooling Technologies, Inc. Printed in USA RECOLD