SD25 Series Screwdrivers

Mapping Screwdriver Functions

This section describes how VS is used to map screwdriver functions to the buttons and switches on the screwdriver. You can also use VS to change the default mapping. To do this, refer to the Visual Supervisor User’s Guide (part number 39-30-34823).

Disabling the Push-to-Start Function

Typically, to start a fastening cycle when the push-to-start function on a handheld screwdriver is disabled:

•Press the throttle/trigger lever to start the fastening cycle.

•Release the throttle/trigger lever to stop the fastening cycle.

•Press to start the fastening cycle

Throttle/trigger lever

• Release to stop the screwdriver

 

Push-to-start

• Disabled

Forward/reverse button

Multi-purpose (auxiliary) button

•Press and release to change the direction

•Press and release 2 times to change the parameter set

Page 14

T-40409-A

39-30-40409