User’s Manual
Mapping Outputs for a Single-Spindle
Typically, the LEDs and headlights on the screwdriver work in the following way:
•Headlights turn on while the screwdriver is running in forward or reverse.
NOTE: Yellow, green and red LEDs chase each other in a
?counterclockwise direction while the screwdriver is in reverse.
•Green LEDs turn on to indicate a successful cycle completion achieving target torque/angle within acceptable range.
•Yellow LEDs turn on to indicate lower than acceptable torque/angle.
•Red LEDs turn on to indicate higher than acceptable torque/angle.
The screwdriver outputs are software selectable using VS. To operate the screwdriver as a single- spindle tool, assign the Cycle Good output to Output 2, Cycle Bad output to Output 3, Output 8 (Timed Copy) to Output 7 and the Ready output to Output 8. The typical outputs for operating the screwdriver as a
NOTE: The time delay for Output 8 (Timed Copy) can be adjusted
?using the Timers tab in VS. For details, refer to the Visual Supervisor User’s Guide (part number
June 2004 | Page 17 |