ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all packing materials from your area and place them back into the box. Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning. If you are missing a part please call our
!WARNING:
1.ALWAYS USE TWO OR MORE STRONG PEOPLE TO UNFOLD OR FOLD THE INTONE JOGGER TRAMPOLINE. FAILURE TO USE TWO OR MORE STRONG PEOPLE MAY ALLOW THE RAILS TO SPRING BACK INTO THE FOLDED POSITION AND STRIKE SOMEONE WHICH CAN CAUSE SERIOUS BODILY INJURY OR DEATH.
2.Keep children away from the INTONE JOGGER trampoline during assembly.
3.Keep fingers away from the ends of the rails in the hinge area when unfolding the INTONE JOGGER trampoline. The INTONE JOGGER trampoline will snap into the unfolded position. Serious injury can occur if fingers are caught between the ends of the RAILS.
4.The SAFETY PAD(6) must be installed before using the INTONE JOGGER trampoline.
NOTE 1 : Check all SPRINGS(24) before assembly. If any SPRING(24) is not attached or damaged, please follow this process to attach or replace the spring:
A.Find the open end of the SPRING(24) and hook this end into the hole on the RAIL(1,2,3,4). Refer to illustration A.
B.Swing the SPRING(24) to face inside of the trampoline. Refer to illustration B.
C.Slide a sharp corner of the metal loop on the MAT(5) into the spring hook as shown in the illustration C.
A. | B. | C. |
Open End
NOTE 2 :
Before assembly, verify that the SECURE PIN(10) is properly inserted in the Frame Rail. The two protrusions must be assembled inside the Frame Rail as shown in the SECTION VIEW of the illustration. Otherwise, it could damage the SECURE PIN(10) during Assembly Step 3.
SECTION VIEW |
Frame Rail |
STEP 1: Lay the trampoline on the floor and open the rails. The trampoline will look as shown in illustration 1.
1.
6
