Standard Horizon HX370S Transmission, Transmit Time OUT Timer TOT, This is AN FCC Requirement

5.3 TRANSMISSION

NOTE

Never key the transceiver without an antenna connected, as this may cause damage to the transceiver.

1.Perform steps 1 through 7 of the RECEPTION discussion above.

2.Before transmitting, monitor the channel and make sure it is clear.

THIS IS AN FCC REQUIREMENT!

3.For communications over short distances, press the H/L key until “” is displayed on the LCD. This indicates Low power (approximately 1 Watt).

NOTE

Transmitting on 1 Watt prolongs battery life. Low power (1 Watt) should be selected whenever possible.

4. If using Low power is not effective, select Medium power (2.5 Watts) or High power (5 Watts) by pressing the H/L key until

“” (Medium power) or “” (High power) is dis- played.

5.When receiving a signal, wait until the incoming signal stops before trans- mitting. The transceiver cannot transmit and receive simultaneously.

6.Press the PTT (Push-To-Talk) switch to transmit. The “TX” indicator is displayed during transmission.

7.Speak slowly and clearly into the microphone. Hold the microphone about ½ to 1 inch away from your mouth.

8.When the transmission is finished, release the PTT switch.

5.4TRANSMIT TIME - OUT TIMER (TOT)

While the PTT switch is held down, transmission time is limited to 5 minutes. This prevents prolonged (unintentional) transmissions. About 10 seconds before automatic transmitter shutdown, a warning beep sounds from the speaker. The transceiver automatically switches to the receiving mode, even if the PTT switch is held down. Before transmitting again, the PTT switch must first be released, then pressed again. This Time-Out Timer (TOT) pre- vents a continuous transmission that would result from an accidentally stuck PTT switch.

HX370S Page 17