Phantom PS1000Page 10
8 INSTALLATION8.1 LOCATION
The radio can be mounted at any angle. Choose a mounting location that:
• is far enough from any compass to avoid any deviation in compass read-
ing due to the speaker magnet
• allows connection to a power source and an antenna
• It is recommended not to mount the antenna closer than three feet from
the Phantom PS1000.
Note: To insure the radio does not affect the compass or radios performance is
not affected by the antenna location, temporarily connect the radio in the de-
sired location and:
a. Examine the compass to see if the radio causes any deviation
b.Connect the antenna and key the radio. Check to ensure the radio is
operating correctly by requesting a radio check.
8.2 ELECTRICAL CONNECTIONS
CAUTION
Reverse polarity connections will damage the radio!
Connect the CMP25 RAM+ microphone, power cord, and antenna to the radio
as shown bellow:
1. Mount the antenna at least 3 feet away from the radio. At the rear of the
radio, connect the antenna cable. It must have a PL259 connector. RG-8/U
coaxial cable must be used if the antenna is 25 feet or more from the radio.
RG58 cable can be used for distances less than 25 feet.
Figure 1. General Installation
GPS Navigation Receiver
Accessory Cable
Antenna
Fuse
Red
Power Source
Black
Water proof
Deck Outlet
CMP25 RAM+ MIC
MLS-310 External Speaker