MAINTENANCE & ADJUSTMENTS
REPLACING THE CHAIN BREAKER PUNCH
If the chain breaker punch (P/N 22801) becomes worn or damaged, use the following procedures for replace- ment.
1.Remove the punch by loosening the set screw (Fig- ure 14).
Figure 14. Removing the Punch
2.Insert a new punch into the holder and push it up until it is fully seated (Figure 15). Secure the punch to the chain breaker holder by fully tightening the set screw.
Figure 16. Rivet Spinner Mounting
2.Lay the chain across the plastic chain supports and then rotate the supports so the rivet head is cen- tered between the take-up handle pocket and the spinner anvil (Figure 17).
Figure 17. Positioning the Chain
3.Turn the take-up handle until the chain is tight against the spinner anvil (Figure 18).
Figure 15. Replacing the Punch
SPINNING RIVETS
The following procedures explain how to spin rivets us- ing Stanley’s
1.Mount the rivet spinner flush with the side or front of a flat, clean work surface (Figure 16).
Rivet SpinnerHandle
Crank
Figure 18. Securing the Chain
4.Turn the rivet spinner crank a few times to center the rivet hub in the spinner anvil (Figure 19).
16 ► DS11 User Manual
