FAULT CODES
FLASH |
| ENGINE |
|
CODE | FAULT | SHUTDOWN | CORRECTIVE ACTION |
|
|
|
|
1 | APECS unit not calibrated | yes | Have engine serviced by an Authorized Stanley Dealer. |
2 | Engine speed excessive | yes | Have engine serviced by an Authorized Stanley Dealer. |
3 | Engine speed unusually low | yes | Have engine serviced by an Authorized Stanley Dealer. |
4 | Engine shutdown due to engine | yes | Have engine serviced by an Authorized Stanley Dealer. |
| protection input |
|
|
5 | Factory settings lost | yes | Have engine serviced by an Authorized Stanley Dealer. |
6 | External pot | no | Have engine serviced by an Authorized Stanley Dealer. |
7 | Accelerator position / idle | no | Have engine serviced by an Authorized Stanley Dealer. |
| switch conflict |
|
|
8 | Controller unit failed | yes | Have engine serviced by an Authorized Stanley Dealer. |
9 | Limiting excessive | no | Have engine serviced by an Authorized Stanley Dealer. |
| actuator current |
|
|
10 | Engine speed input | no | (Active only in Auto crank mode). |
| signal missing |
| Check speed sensor wiring. |
|
|
| Check starter motor. |
11 | Auto crank unable to | no | Check fuel. |
| start engine |
|
|
12 | Auxiliary output is shorted | no | Check the lamp or relay hooked to the output. If fault is |
|
|
| still present, have engine serviced by an authorized |
|
|
| Stanley Dealer. |
13 | Auxiliary output #2 is shorted | no | Check the lamp or relay hooked to the output. If fault is |
|
|
| still present, have engine serviced by an authorized |
|
|
| Stanley dealer. |
14 | Actuator disconnected or | no | Check actuator wiring and actuator resistance. |
| open circuit |
| Resistance should be less than 10 ohms. |
16 ►