Stanley Black & Decker SK58 user manual Tool to Hydraulic Circuit Hose Recommendations

8 ► SK58 User Manual

Tool to Hydraulic Circuit Hose Recommendations

The chart to the right shows recommended minimum hose diameters for various hose lengths based on gallons per minute (gpm)/ liters per minute (lpm). These recommenda- tions are intended to keep return line pressure (back pressure) to a minimum acceptable lev- el to ensure maximum tool performance.

This chart is intended to be used for hydraulic tool applications only based on Stanley Hy- draulic Tools tool operating requirements and should not be used for any other applications.

All hydraulic hose must have at least a rated minimum working pressure equal to the maxi- mum hydraulic system relief valve setting.

All hydraulic hose must meet or exceed specifications as set forth by SAE J517.

Oil Flow		Hose Lengths		Inside Diameter		USE	Min. Working Pressure
						(Press/Return)
GPM	LPM	FEET	METERS	INCH	MM		PSI	BAR
		Certified Non-Conductive Hose - Fiber Braid - for Utility Bucket Trucks
4-9	15-34	up to 10	up to 3	3/8	10	Both	2250	155
	Conductive Hose - Wire		Braid or Fiber Braid -DO		NOT USE NEAR ELECTRICAL CONDUCTORS
4-6	15-23	up to 25	up to 7.5	3/8	10	Both	2500	175
4-6	15-23	26-100	7.5-30	1/2	13	Both	2500	175
5-10.5	19-40	up to 50	up to 15	1/2	13	Both	2500	175
5-10.5	19-40	51-100	15-30	5/8	16	Both	2500	175
5-10.5	19-40	100-300	30-90	5/8	16	Pressure	2500	175
				3/4	19	Return	2500	175
10-13	38-49	up to 50	up to 15	5/8	16	Both	2500	175
10-13	38-49	51-100	15-30	5/8	16	Pressure	2500	175
				3/4	19	Return	2500	175
10-13	38-49	100-200	30-60	3/4	19	Pressure	2500	175
				1	25.4	Return	2500	175
13-16	49-60	up to 25	up to 8	5/8	16	Pressure	2500	175
				3/4	19	Return	2500	175
13-16	49-60	26-100	8-30	3/4	19	Pressure	2500	175
				1	25.4	Return	2500	175

PRESSURE

<<< FLOW

RETURN

FLOW >>>

HOSE RECOMMENDATIONS

Figure 1. Typical Hose Connections