CONTROL OVERVIEW M.212
| DC 6V |
|
|
|
16 | 17 | 18 | 19 | 20 21 22 |
16.Power Switch - Turns unit off and on.
17.Power Connector - Plug in the included power supply here.
18.Fader Start Control Jacks - Connect these jacks to the Fader input jacks of the CD player using the 3.5mm stereo mini cord.
19.Master Output - Unbalanced RCA connectors controlled by the Master level.
20.Line Inputs - Unbalanced RCA jacks for connecting stereo audio from line level sources such as CD players, HiFi VCRs, cassette decks, DAT machines, laser discs, tuners, even synthesizers or other mixing consoles.
Note: Plug mono audio sources into both Left and Right inputs using a "Y" cable connector.
21.Phono Inputs - Plug your turntables in here. When these connectors are used, your signal is fed directly to the
22.GND - Connect each of your turntable ground leads to either of the two ground terminals.
.
SETUP M.212
Review this setup diagram. Make sure all faders are at "zero" and all devices are off. First, connect all input sources and processors. Next, connect your microphone and monitor headphones. Finally, connect the stereo outputs to the power amplifier(s) and/or audio receivers such as tape decks. Plug your mixer into AC power. Now you are ready to switch everything on.
IMPORTANT: Always switch on your audio input sources, such as turntables or CD players first, then your mixer, and finally any amplifiers. When turning off, always reverse this operation by turning off amplifiers, then your mixer, and then input devices.
POWER AMP.
POWER |
|
SUPPLY | DC 6V |
TURNTABLE
C.324. | C.324. |
5
