S-250 FUNCTIONS
1)EJECT: Opens the CD door
2)STOP: Stops the CD.
3)SKIP: Skips through the tracks on the CD, forward or back.
4): Scans forward or back through the current track.
This unit features 3 scan speeds. Keep the or button pressed for a few seconds to change the scan speed.
5)PLAY/PAUSE: Plays or pauses the CD. Autocue function sets the cue point automatically when this button is used.
6)CUE: Used to recall and preview the cue point.
7)TIME: LCD display reads the time remaining or time elapsed, according to this button.
8)PITCH: Turns pitch fader ON and OFF.
9)PITCH SELECT: Pressing the PITCH and PITCH BEND - (minus) buttons simultaneously changes the pitch fader range between +/- 8, 12, and 16%.
10)PITCH BEND: Maximum pitch on this unit is 16%. If the pitch fader is already physically set to 16%, this function will not work.
11)SGL/CTN: Switches between Single or Continuous play modes.
12)LOOP: Press once to set starting loop point, press again set ending point and enter loop. Press a third time to exit loop.
13)LCD DISPLAY: Shows time (minutes, seconds, frame), and pitch information.
14)PITCH FADER: Used to speed up or slow down current track.
15)AUDIO OUT: This stereo line output connects to the line input on any DJ mixer.
16)DIGITAL OUTPUT: This coaxial (S/P DIF) digital output connects to any RCA S/P DIF input, as found on most standard computer sound cards or CD burners.
17)FADER START: Connects to any DJ mixer equipped with a fader start input. This enables the user to start the CD from the cue point, using the mixer＇s cross or line fader, depending on the mixer.
18)VOLTAGE SELECTOR: Used to select the unit’s voltage
according to the local setting. Note: The voltage should preset correctly from the factory, however, make sure to check it before powering the unit.
*Just for Dual Voltage only.
19)AC IN: This is the connection for the supplied power cable.
20)POWER: This button is used to power the unit ON and OFF.
21)PHONES: Use this stereo jack to connect a pair of headphones.
