Stanton SK 6F T R O U B L E S H O O T I N G, Pl Ease Read Caref Ul Ly B E F O R E U Se, Problem

Thank you for making Stanton your first choice in professional DJ mixers.

This innovative family of mixers has been developed with input from the professional DJ community, bringing to the marketplace a previously unavailable, affordable combination of user-friendly, functional design, rugged construction, and professional quality features.

Stanton and your authorized Stanton dealer are dedicated to your complete satisfaction by offering benchmark service and support throughout the long life of your Stanton product.

Again, we appreciate your patronage, and look forward to many years of making music together.

PL EASE READ CAREF UL LY B E F O R E U SE

FAILURE TO FOLLOW THE INSTRUCTIONS PRINTED BELOW MAY VOID WARRANTY

•Follow all security advice printed on your mixer

•When removing the unit's AC plug from the power source, grasp and pull the plug, NEVER the cord itself!

•Avoid placing your mixer near heat sources, such as power amplifiers.

•When in use, place your mixer on a stable surface, away from vibration. Always use care when carrying your mixer. Impact, or heavy vibration may compromise the unit's mechanical integrity. The manufacturer is not responsible for damage resulting from an impact, or misuse.

•When in use, place your mixer away from sources of hum or noise, such as transformers, or electric motors.

•To prevent overheating, always provide your mixer with adequate ventilation air space.

•Avoid stepping on your mixer's AC cord. Repeated compression of the cord may lead to electrical shorting.

•To avoid damage due to AC voltage peaks, always disconnect your mixer from the power source during electrical storms.

•Your mixer contains no user-serviceable parts. The manufacturer is not responsible for any damage or personal injury resulting from unauthorized user-servicing or modifications. In addition, the warranty will be void if any unauthorized service by the user is detected. Always return your mixer to an authorized Stanton dealer for servicing.

T R O U B L E S H O O T I N G

PROBLEM	CAUSE	SOLUTION
Excessive hum when using	Poor ground connection.	Properly connect turntable
phono source.		ground wire to mixer ground
		terminal.
Low frequency hum while	Poor AC source ground.	Properly ground the AC
operating source unit.	Loose input/output connec-	source. Check all input and
	tion. Shorted cable.	output connections for
		secure fit. Isolate and
		replace damaged cable.
Program volume	Amplifier or outboard gear	Connect amplifier or out-
can’t be adjusted with	connected to the record	board gear to master out -
master volume control.	output.	put.
No power.	Improperly connected AC	Properly connect AC cord to
	cord or power line source	AC power source. Turn
	not on.	power on.
The amplifier is turned up,	Faulty output connections	Properly connect amplifier,
but there is no signal.		or outboard gear to mixer.
	Improper level adjustment.	Properly set crossfader,
		channel faders, gain con-
		trols, and input selector tog -
		gles.
No signal in headphones.	Improper connection.	Check headphone connec-
		tion to mixer. Tighten if nec-
		essary.
	Improper level or cue mix	Adjust headphone level and
	settings.	cue mix to the proper level
		and channel settings.