CONTROLS OVERVIEW |
|
1 | 20 |
2 | 19 |
| |
| 18 |
| 17 |
3 | 16 |
4 | 15 |
5 | 14 |
| 13 |
6
2
7
21 22 23 24
1.REVERSE - This button is used to reverse the direction of the platter rotation.
2.START/STOP - Press this button to start or stop the platter.
3.STROBE DOTS - The dots around the edge of the platter are used in conjunction with the light located inside the motor ON/OFF switch. While the platter is in rotation, the dots help to indicate the speed of rotation. The speed is lower than the displayed speed (33,45,78) when the dots are flowing to the right. It is higher than the displayed speed (33,45,78) when the dots are flowing to the left. When the strobe is stopped, the platter is rotating at the displayed speed.
4.SLIP MAT
5.CENTER SPINDLE - This spindle holds the turntable PLATTER record stable and centered.
6.MOTOR ON/OFF SWITCH - As opposed to fully analog turntables, this is not the power switch. This switch only turns the motor on or off. Rotate clockwise to turn on the motor. The platter will not start spinning until the start/stop button has been pressed. Rotate counterclockwise during playback (off position) for a slow winding down effect.
7.PLATTER SPEED BUTTONS (rpm)
33 rpm – Press 33
45 rpm – Press 45
78 rpm – Press the 33 and 45 buttons simultaneously.
To return to 33 or
12
11
10
T. 9 2 U S B
89
2526
8.HEADSHELL - Install the cartridge here per the “Tonearm and Cartridge Settings” section of this manual.
9.KEY LOCK - Press to enable key lock. When KEY LOCK is on, the pitch slider will only affect the speed of the platter. The key (pitch) will remain fixed. This speeds up the musical tempo without changing the pitch.
10.HEADSHELL LOCKING NUT - Attach the headshell by inserting into the front end of the tone arm. Turn the locking nut clockwise with the head shell firmly held horizontally.
11.PITCH ON/OFF INDICATOR - When this indicator is illuminated the speed of the platter is locked in either 33 1/3, 45, or 78RPM via the quartz lock feature depending on which RPM the PLATTER SPEED BUTTONS are set to.
12.PITCH SLIDER - This slider is used to speed up or slow down the turntable platter. Pitch speed is often changed in DJing to match corresponding tempo’s of two records
13.TONE ARM - This is a fully manual tone arm. To start playback, gently place the stylus on the record using the headshell finger support. Do not drop the stylus onto the record as it may cause damage to the diamond tip and to the record.
14.PITCH SELECT - Press the button to select between
15.TONE ARM CLAMP AND REST - Use this rest for the tone arm and clamp it in position during transportation.
4
