3-74STARCommandSpecications

Rev. 0.70
ESC d n
[Name] Paper cut instruction
[Code] ASCII ESC d n
Hexadecimal 1B 64 n
Decimal 27 100 n
[DenedArea] 0≤ n ≤ 3
48 ≤ n ≤51(“0”≤ n ≤“3”)
[Initial Value] ---
[Function] Thiscommandexecutestheauto-cutaccordingtothenspecication,afterprintingdatainthelinebuffer.
 Afterauto-cutterisexecuted,theprinterconsidersthatpositiontobethetopofthepage.
n Auto-cutter
0, 48 Full cut at the current position.
Thiscommandisignoredontear-barmodels.
1, 49 Partial cut at the current position.
Thiscommandisignoredontear-barmodels.
2, 50 Paper is fed to cutting position, then a full cut.
Ontear-barmodels,paperisfedtothecuttingposition.
3, 51 Paper is fed to cutting position, then a partial cut.
Ontear-barmodels,paperisfedtothecuttingposition.
The auto-cutter function operates in the following ways on models that only have a full cut or a partial cut.
• Models that perform only a full cut: Executes a full cut when for instructions calling for a partial cut.
• Models that perform only a partial cut: Executes a partial cut when for instructions calling for a full cut.
 Thecuttingpositionistheposition(afterdetectionoftheblackmark)setbytheESCGS(F(Settopofform
amountinblackmarkcontrol).
 Ifnotsetbythesecommands,paperisfedtotheinitialpositionsetbythememoryswitch.
 •Thecuttingposition(blackmark)variesaccordingtothepaperusedandtocustomerspecications.
 •Refertotheprinterproductspecicationsyouusefordetailsregardingthedistancetothecuttingposition
(thephysicalvaluefromtheblackmarktotheprintheadtothecutterposition).