![Setting of the DIP Switches](/images/new-backgrounds/111167/11116763x1.webp)
Setting of the DIP Switches |
|
| |
|
| Factory settings : all ON | |
Switch | Function | ON | OFF |
1 | Character Table (See below) |
|
|
2 |
|
|
|
3 | Control cord CR | Disable | Enable |
4 (*1) | Printing Direction (Red printing) | Bi. | Uni. |
5 (*2) | Ink Ribbon | monochrome | |
6 |
|
|
|
7 | International Character Set (See below) |
|
|
8 |
|
|
|
(*1) DIP Swich 4 should be set to OFF when you use
The DIP Switch 4 Should be otherwise set to ON.
(*2) DIP Swich 5 should be set to ON when you use a
It should be set to OFF when a monochrome ribbon is used.
Character Table
SW NO. | USA & Europe | IBM#1 | IBM#2 | JAPAN |
|
|
|
|
|
1 | ON | OFF | ON | OFF |
2 | ON | ON | OFF | OFF |
International Character Set
SW NO. | USA | France | Germany | England | Denmark | Sweden | Itary | Spain |
6 | ON | OFF | ON | OFF | ON | OFF | ON | OFF |
7 | ON | ON | OFF | OFF | ON | ON | OFF | OFF |
8 | ON | ON | ON | ON | OFF | OFF | OFF | OFF |
Note: When DIP Switches 1 and 2 are set to OFF, the printer always selects the Japan international character set regardless of the status of DIP Switches 6, 7 and 8.
When DIP Swiches 1 and 2 are otherwise set, the printer selects the character set determined by DIP Switches 6, 7 and 8.
Each international character set is selectable through software regardless of the selection by DIP Switches.
Figure
– 28 –