– 12 –
6. DISPLAYS AND FUNCTIONS
The LEDs and RESUME button are mounted on the NEPCB.
6.1 LEDs
6.2 RESUME Button
When no paper is inserted, insert more paper, then press this button to automatically feed the specified
length of paper (approx. 80 mm when the presenter is installed or approx. 30 mm when it is not). After
the paper is cut, the printer will go back on line.
6.3 Power Switch and Button Combinations
The following settings can be made by pressing either the RESUME button or the sensor adjusting but-
ton at the same time that the power switch is turned on.
<RESUME button and power switch>
<Sensor adjusting button and power switch>
Note) The Line and Page modes cannot be chosen with the panel buttons; these modes can only be
chosen with commands.
LED Function
HU Lights up when errors occur
(For more details, refer to “6.6 Error Messages”.)
PE
ERR
Buzzer LED Function
One beep HU lights up
↓
2 sec. Release the RESUME button to execute a HEX dump.
[*1]
Two beeps PE lights up
Release the RESUME button to execute a test print. [*2]
[*1] The HEX dump mode remains valid until the power is turned off.
[*2] The printer continues the test print until the power is turned off.
Buzzer LED Function
One beep HU lights up
↓
2 sec. Release the sensor adjusting button to start sensor
adjusting mode. [*3]
[*3] Do not continue pressing the sensor adjusting button for more than two seconds.