– 13 –
6.4 Sensor Adjusting Mode
a) Reflecting sensor (black mark sensor)
●
Insert the paper in front of the sensor mechanism so that a black mark is not positioned in front of
the sensor.
●
Adjust the reflecting sensor controller VR4 on the PCB until the HU LED lights up.
b) Paper-out sensor
●
Insert the paper in front of the sensor mechanism so that a black mark is not positioned in front of
the sensor.
●
Adjust the paper-out sensor controller VR3 on the PCB until the PE LED lights up.
6.5 Near-End Sensor
Selecting the open frame setting with memory switch B enables near-end sensors A and B. It is possi-
ble to determine the state of near-end sensors A and B by outputting the <EOT> command to the
printer. (This is only possible when a serial interface is used.) Refer to “Programmer’s Manual”.