Star Trac E-STi, E-TBTi, E-RBi, E-UBi, E-TRi manual Installing Your Personal Viewing Screen PVS

INSTALLING YOUR PERSONAL VIEWING SCREEN (PVS)

The Star Trac Personal Viewing Screen is different for each of your Star Trac E-Series Cardio prod- ucts. Make sure you have the proper kit for the E-Series product you are installing. The E-UBi, E-RBi, E-TBTi, and the E-STi will follow the same basic steps for installation. For the E-TRi turn page 18 in this section.

To install on the E-UB, E-RB, E-TBT, and the E-ST, follow these steps:

STEP 1

Using a #2 Phillips screwdriver, remove the (8) screws on the back of the display plastic. Set the screws aside, you will need them for reassembly.

STEP 2

After the screws have been removed, carefully open the display plastic, so as to not detach the inner cables from the display.

Disconnect the ground wire 1 between the Heart

Rate board and the display mount.

1

STEP 3	2	3
Disconnect the 12-pin serial connector 2	and
the Heart Rate cable 3 from the display.

10 STAR TRAC PERSONAL VIEWING SCREEN OWNER’S MANUAL