Once the necessary settings have been made, click on OK. The Hyper Terminal window will appear - if all settings are correct, the time clock at the lower left corner of the terminal window will indicate “connected” and the hh:mm:ss timer will begin counting.
Hyper Terminal for COM Port
Initiate another Hyper Terminal connection as a COM Port Terminal. To do so, follow the previously listed steps (see HyperTerminal for TCP Winsock), used to create a Hyper Terminal for TCP/IP WinSock, but instead of selecting TCP/IP (Winsock), select COM
1 (or another COM Port). Set the COM port Properties such that they are identical to those set for the Serial port.
Data Transmission
Once the Hyper Terminals have been setup for both COM Port and TCP/IP Winsock, type any characters in the COM Port Terminal and verify that the typed characters are also displayed in the TCP/IP Winsock terminal. Alternatively, check if the characters typed in the TCP/IP WinSock Terminal are also displayed in the COM Port Terminal. If yes, then all settings are correct, and the converter can operate properly.
Troubleshooting
If the Device Management Utility (ETM.exe) doesn’t detect the converter on the network:
Please verify:
•The power is properly connected to NETRS2321E
•The network cable is properly connected between NETRS2321E and the hub
•There is no firewall interference. If the computer you are using is Windows XP, the Windows Firewall function may be enabled, which will block the Device Management Utility from detecting the NETRS2321E IP Address. Therefore, you may temporarily disable the Windows Firewall function, and
If you cannot setup the NETRS2321E using Internet Explorer:
Please verify that the network domain of the PC is the same as the converter.
Instruction Manual
15
