NOTE: Because the Device Management Utility uses broadcast UDP packets, configuration is only allowed when the device’s password is left empty.
Web Console Configuration
In addition to basic IP Address and subnet mask, specific device settings can be set using an Internet browser, such as Internet Explorer or Netscape etc.
If the IP Address of the adapter is already known (default is 192.168.0.10), enter it into the browser address line to launch the Login Page.
The Login Page
Once the Login Page has been launched (as shown on page 6), the following will be displayed:
System time elapsed
The time elapsed since the adapter was connected to the LAN will be displayed here.
Firmware version
The installed firmware will be identified here by date code.
Serial number
The adapter serial number consists of five digits and a unique MAC address used by the network in hexadecimal format.
Password (Setup login)
This field allows you to enter the administration password for authentication. By default, the password is left empty. If you have changed the password to something other than the default, press and hold the Reset button (located next to the RJ45 port) for five seconds. The adapter will power cycle; once it has been
Instruction Manual
6
