8
Initial Power-Up
Make sure all computers and StarViews are powered down
during installation. You must power up the Master StarView
before turning on any other devices.
4 For single StarView: 1) Apply a power adapter to the Master.
2) Turn on computers.
4 For cascade: 1) Apply a power adapter to the Master.
2) Apply power adapters to all Slaves. 3) Turn on computers.
Note: You may hot plug additional powered-down computer and
Slave without turning any existing StarView or computer off after
initial power up.

Replace Master Console Devices

You can replace a faulty keyboard or mouse of the Master
CONSOLE port at any time without powering down the Master, as
long as your computers are booted with proper device driver for the
new device. Should you encounter any difficulty, just activate K/M
RESET by holding both front-panel ‘1’ and ‘2’ push buttons down for
2 seconds.

Adhesive Rubber Foot

For desktop operation, you may stick the four round rubber feet
(supplied with the unit) to the bottom of the StarView. NOTE: Do not
use the rubber feet for rack mount operation.