3.When the copy has completed, the LCD display will show the total time it took to copy, the number of passes, and if there were any failures.
NOTE:
a)When the copy is in progress, the green LED will flash for each Flash drive that is connected. When the copy has finished, the green LED will stop flashing and remain illuminated. If an error occurs, the red LED will illuminate.
b)Do NOT remove the Flash drives while the system is copying (green LED is flashing). You can cancel duplication by pressing ESC.
c)It is recommended that the source and destination are the same size. Copying to or from a larger Flash drive may cause an error and the copy will fail.
d)If copying a Flash drive with NTFS or Linux file formats, the destination capacity MUST BE equal or larger than the source’s capacity.
1.2 Asynchronous Copy
NOTE: This mode is enabled by default. The source’s content size must be smaller than the system’s buffer memory, otherwise the system will automatically duplicate in Synchronous mode.
To enable Asynchronous mode, go to function “7.6 Asynchronous”, and select “Enable”.
Operating Process
1.Plug in the source Flash drive, and press OK. The system will start to read the source’s content into the system’s buffer. Once completed, it will immediately start to copy once a destination Flash drive has been plugged in.
Instruction Manual
6
