7.2.2 Whole Media
Set the system to copy the entire Flash drive’s content, including empty space and file format.
7.3 Button Beep
Turn audio feedback ON/OFF. ON by default.
7.4 Asyn Hold time
Set the time to cancel an Asynchronous copy when you’ve temporarily finished copying and all of the Flash drive devices have been removed, but the copy job has not been manually cancelled. This is to prevent mistakenly overwriting your source drive when you’d like to start a new source copy but the previous Asynchronous copy job has not yet been cancelled.
The default is 30 seconds. When the system no longer detects any Flash drive for 30 seconds, the system will prompt you to either exit or keep the current copy job.
7.5 Target Tolerance
Set the tolerance of the capacity gap between the source and destination ports in %. There are three modes, with the default being ‘no limit’, as follows:
a)Allow Tolerance: Users can set the high and low limit (%) of capacity difference between the source and destination drive separately.
b)No Limit: Users can disable the capacity limit between the source and destination drive. If the data on the source drive is larger than the capacity of the destination drive, this will lead to an incomplete/failed duplication.
c)100% same: Users can set the capacity of the destination drives to be the exact same as the source drive. If the sizes do not match, the duplication will not start.
7.6 Asynchronous Mode
Choose to disable or enable Asynchronous copy mode. If enabled and the data on the source is smaller than the system’s buffer memory, it will automatically use asynchronous when copying. If disabled, the system will copy in synchronous mode.
This mode is enabled by default.
7.7 Check before Copy
Choose to enable or disable the system checking the Flash drive before starting a copy. By default, the drive is not checked before copying.
7.8 Power off time between Copy + Compare
When performing the Copy + Compare function, set the wait time (in seconds) after a Copy has completed, and before the Compare starts. The default is 3 seconds.
7.9 Language
Change the system language between English and Japanese.
Instruction Manual
12
