Roland VC-1 D-50 owner manual Try Out the Sounds, Turning On the Power

Try Out the Sounds

Turning On the Power

To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections.

fig.03-01e(ConnectionImage)

1. Before hooking anything up, make sure that the power on all of your gear is turned OFF.

2.	Connect the V-Synth XT to your amp/speaker system.
3.	Turn on the V-Synth XT’s Power switch.
4.	Turn on the power for any connected amplifiers or speakers.	Mixer, etc.
5.	After the V-Synth XT has started up, press the [V-CARD] button and touch “D-	Monitor Speakers
	50” (VC-1) in the screen that appears. The VC-1 Startup screen appears.
		Power amp

*When you turn on the power, the V-Card that was most recently started will start up.

6.Wait for the VC-1 to start up. When it has started up normally, a screen like the following will appear. The

display shows the selected Patch.

fig.03-02e(Card&LCD_default)

Tone name

Patch name

Patch number

Key mode

Split point

The volume balance of the Upper & Lower Tone

11