State Industries 101, 100 warranty Ultra Force SUF 120 250A ROUGH-IN-DIMENSIONS, Foreword

ULTRA FORCE SUF 120 - 250A ROUGH-IN-DIMENSIONS

GAS VALVE PIPING

SUF-120, 199 & 250 SUF-150

1/2" NPT 3/4" NPT

Table 1. RECOVERY CAPACITIES - NATURAL GAS / L.P.

			Approx.
	Input	Gas	Gallon		TEMPERATURE RISE - DEGREES °F - GALLONS PER HOUR
Model	BTU/Hr.	Usage	Capacity	30		40	50	60	70	80	90	100	110	120	130	140
SUF 120	120,000	nat/lp	60	461		345	276	230	197	173	154	138	126	115	106	99
SUF 150	150,000	nat/lp	100	576		432	345	288	247	216	192	173	157	144	133	123
SUF 199	199,900	nat/lp	100	767		575	460	384	329	288	256	230	209	192	177	164
SUF 250	250,000	nat/lp	100	960		720	576	480	411	360	320	288	262	240	221	206
			Approx.
	Gas	Liter	TEMPERATURE RISE - DEGREES C - Liters PER HOUR
Model	kW-Hr	Usage	Capacity	17	22		28	33	39	44	50	56	61	67	72	78
SUF 120	35	nat/lp	227	1744 1308			1046	872	747	654	581	523	476	436	402	374
SUF 150	44	nat/lp	379	2179 1635			1308 1090		934	817	726	654	594	545	503	467
SUF 199	58	nat/lp	379	2904 2178			1743 1452 1245 1089				968	871	792	726	670	622
SUF 250	73	nat/lp	379	3632 2724			2179 1816 1557 1362				1211	1090	991	908	838	778

Recovery capacities are based on 95% thermal efficiency.

FOREWORD

These designs comply with the current version of the American National

Standard for Gas Water Heaters, Volume III, ANSI Z21.10.3 / CSA 4.3 as

an automatic circulating tank water heater, and automatic storage water

heaters.

Detailed installation diagrams are found in this manual. These diagrams will

serve to provide the installer with a reference for the materials and methods

of piping necessary. It is highly essential that all water, gas piping and wiring be installed as shown on the diagrams.

Particular attention should be given to the installation of thermometers at the locations indicated on the diagrams as these are necessary for checking the proper functioning of the heater.

In addition to these instructions, the equipment shall be installed in accordance with those installation regulations in force in the local area where the installation is to be made. These shall be carefully followed in all cases. Authorities having jurisdiction should be consulted before installations are made.

In the absence of local codes, the installation must comply with the current editions of the National Fuel Gas Code, ANSI Z223.1/NFPA 54 and the National Electrical Code, NFPA 70 or CAN/CSA-B149.1, the Natural Gas and Propane Installation Code and CSA C22.1, the Canadian Electrical Code. All documents are available from the Canadian Standards Association, 8501 East Pleasant Valley Road, Cleveland, OH 44131. NFPA documents are also available from the National Fire Protection Association, 1 Batterymarch Park, Quincy, MA 02269.