Operating (cont’d)
WARNING
BEFORE LIGHTING [PROPANE (L.P.) GAS WATER HEATERS]: Propane (L.P.) gas is heavier than air. Should there be a leak in the system, the gas will settle near the ground. Basements or crawl spaces, closets and areas below ground level will serve as pockets for the accu- mulation of this gas. Before attempting to operate the heater or turning a nearby electrical light switch, be absolutely sure there is no accumulated gas in the area. Search for odor of gas by sniffing at ground level in the vicinity of the appliance. If odor is detected, follow the steps indicated at “For Your Safety” on the cover page of this manual, then leave the premises.
Operating instructions are located on front of the water heater, above or to one side of the gas control valve.
WARNING
AN ODORANT IS ADDED TO THE GAS USED BY
THIS WATER HEATER. FOR YOUR SAFETY
IF YOU SMELL GAS:
1.Do not try to light any appliance.
2.Do not touch any electrical switch; do not use an phone in your building.
3.Immediately call you gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
4.If you cannot reach your gas supplier, call the fire department.
WARNING
DO NOT force the gas control knob. Use only your hand to turn it to “ON” or “OFF”. Never use a tool such as a lever, wrench or pliers. Do not hit or damage the knob. A damaged knob may result in an explosion and serious injury. If you have problem turning the knob, call the gas supplier immediately.
CHECK FOR LEAKS
Be sure to check all your gas pipes for leaks before lighting your water heater. Use a soapy water solution, not a match or open flame. Check the factory gas fittings when the main burner is turned “ON”. Use a soapy water solution for this, too.
Figure 8
Figure 9
Figure 10
INNER DOOR
OUTER DOOR
22
