Sterling 2 owner manual Transportation

Transportation

Transportation

Your scooter may be disassembled quickly and

simply for transportation.

­1. Engage the drive unit by pushing the freewheel lever backwards to stop the scooter from moving during docking and transportation.

2.Lift off the front basket.

3.Remove the seat and seat stem locking pin, leaving the seat stem in position.

4.Remove the battery pack locking screw and battery pack. Re-insert the battery locking screw in the battery post once the battery has been removed. Transport battery pack in the upright position.

5.Lower the tiller, turning it slightly past the seat stem to its lowest setting, using the adjustment lever provided (Photo 14.1).

6.Lock the tiller by inserting the seat stem locking pin through the hole in the left hand handle bar tube. This will prevent the tiller from moving during lifting and transport (Photo 14.2).

7.De-dock the rear drive unit by lifting the docking handle and moving the front frame forwards.

Note: The battery pack MUST be removed before the scooter can be de-docked (Photo 14.3).

8.Using the lifting handles provided carefully lift

the scooter safely and securely into the luggage compartment of the vehicle (Photo 14.4).

TIP:

Lift the front wheels in first and use these to roll the frame along. Use the step at the boot opening to rest parts if required (Photo 14.5).

To reassemble the scooter reverse the sequence above.

Photo 14.1

Photo 14.2

Photo 14.3

Photo 14.4

Important:

When reassembling the scooter, remember to insert the battery locking screw, because failure to do so may result in the batteries disengaging during use. Always secure your scooter parts before transportation. Do not sit on your scooter whilst it is being transported in or on another vehicle.

Photo 14.5

14 Iss 1