Routine maintenance
The following table gives an indication as to when routine maintenance checks should be made.
There is no service manual available.
Maintenance, fault finding and servicing should be carried out by an authorised dealer unless otherwise indicated.
The checks below can be carried out by the user
Battery charge check (Fig. D)
Look at battery charge indicator on tiller before use to ensure batteries are fully charged.
Inspection of connectors (Fig. C)
Remove batteries and rear drive unit and ensure all connectors are secure.
Wipe over with a damp cloth
Use a damp soft cloth and mild detergent on panels, battery wells, tiller and seat.
Check tyres & tyre pressures
Each tyre should be free of debris, oil, deep cuts or distortion.
Long overnight battery charge
Please ensure that the battery pack is charged for a minimum of 8 hours.
Check tyres for wear (See Fig. A and Fig. B)
Look at the tyres to ensure that the tread is visible and continuous.
The checks below must be carried out by an authorised dealer Seat swivel, seat slide (where fitted)
Inspection of wiring and connectors for chafing and wear
Battery terminals
Clean and protect with petroleum jelly.
Ensure parking brake (where fitted) is correctly adjusted
Check stabiliser wheels for wear
Inspect motor brushes
Full service by dealer
Daily
Weekly
Quarterly
Annually
Fig. A | Fig. B |
Storage
When storing your scooter for long periods (in excess of one week), charge batteries for 12 hours and then disconnect the batteries to minimise battery discharge.
Electronic faults
Do not attempt to investigate faults in the control box, the control pod or charger as the design and set up of the electronics is of a safety critical nature. Spare parts and service are available from authorised dealers.
Fig. C | Fig. D |
Replacing LED`s (where fitted)
Caution! Disconnect batteries before changing LED`s.
Rear light - Contact Dealer
Headlight - Contact Dealer
Wheels
Note: Wheels should only be removed and refitted by an authorised dealer.
30 | Iss 1 |
|
|
|
|
